Yes some men are as stupid and as pill fucked as feminists. Yes Really.

I wanted to buy some steel tube to make a jack handle....

I figured that 30mm x 30mm (outside size of square tube) with a wall thickness of about 3mm would be about right.

But I figured that I'd like the handle to be detachable, and the easiest way, would be to get some slightly larger steel tube to stick the handle in...

Sort of like foot in shoe - so to speak.

So the drug fucked / pilled out cunt - who is PURE idiot,  always arguing about whether "they can" cut the steel I want to LENGTH -

"Ooooorrrr snot very accurate maaaate - might be a few mil out... Just have to wear it mate..."

So he thinks that say plus or minus 3 or 4 mm each way of the right length is OK...

Well no it's not, and that is what rulers and tape measures are for.....

I think plus or minus about 0.25mm each way, is OK for a rough cut.

And it takes no more time to measure it wrongly as it does to measure it rightly.



On the type of saw I want it cut on....

"Awwwwww maaaate - don't know if we can do it on that one (the one that makes accurate square cuts), might have to do it on another one (that makes shitty weavy cuts with BAD burrs all around it).

Depends if they are busy or not..."


You know, I am paying this dumb cunt to cut the steel I want, to the lengths I want, on the machine I want, and I expect the jobs to be cut on a first come first serve basis and I am in no hurry.....

And the dumb cunt is arguing about every possible thing, to fuck it all up, every step of the way ...

And the last two times I rang this fuck - same crap, same stupidly obstructive shit, every step of the way....

Well I gave him or some other dumb fuck in that office, a final try.


"Well I want some 30 x 30 x 3 square tube - and I want some thing a little larger to sleeve it into..."

"Ohhhhh  how about some 65 x 65 with a 5mm wall thickness?"

e.g.

Mental Calculations:

65mm outside size, minus 2 x 5mm (10mm) = 55mm size hole on the inside....

55 - 30 = 25mm of slop between the two tubes....

I say, "Mate that gives 25mm of slop between the parts, that is not a neat fit...."



Then he goes, "Ohhhh how about some 60mm square with 6mm wall thickness?"

I figure that this guy is pilled out of his fucking mind and for someone who has been working in the steel industry as a sales man - for a fucking long time, where they distribute, cut and deliver - and sleeving steel tubing is a fairly common practice, and this guy is so fucking out of it he can't even do basic maths and consistently is fucking this up and we are headed for round three....

I ended the call and went else where.